QUADEC features a squared edge and is used on the outer rim of the bench. DILEX-EKE, in sand pebble, is used for the floor-to-wall transition. KERDI-BOARD building panels are used to create the two-tiered bench and partition wall. The KERDI-BOARD-ZA U-shaped profile is used to finish the edges of the partition wall. KERDI-DRAIN in anodized aluminum with a brushed nickel grate is featured in the center of the shower. KERDI, KERDI-BAND, KERDI-KERECK, and KERDI-SEAL-PS/-MV provide waterproofing from the floor to the ceiling behind the tile.
DILEX-EKE in sand pebble is featured in the inside corners of this beige shower, and KERDI-DRAIN is shown with a brushed nickel grate.
The DILEX-EKE in sand pebble blends in seamlessly to these inside wall corners.
QUADEC is applied to the outside corner of the bench, while the DILEX-EKE in sand pebble eliminates the need for caulking, and creates a subtle floor/wall transition.
The QUADEC profile creates a square-edged trim to the front of the bench, while the DILEX-AHK creates a cove-shaped smooth transition to the wall.
Finishing and edge-protection profile with a squared reveal surface
Anodized aluminum cove-shaped profile for inside wall corners and floor/wall transitions with limited movement
Corner movement joint profile for inside wall corners and floor/wall transitions
Waterproof, multifunctional tile substrate and building panel
U-shaped profile for finishing partition walls and shelves
Floor drain with integrated bonding flange
Bonded waterproofing and vapor-retardant membrane
Waterproofing strip for sealing abutting joints of Schluter® membranes and building panels
Preformed, waterproofing corners
Prefabricated seals for pipe protrusions