Two-part profile with tapered edge to cover adjoining tile edges

The Schluter®-SHOWERPROFILE-S is a two-part profile with a tapered edge, designed to cover adjoining tile edges that become exposed as the shower floor slopes to accommodate drainage to the KERDI-LINE linear drain.
  • Features a visible surface of brushed stainless steel and a fleece fabric on the reverse for bonding with the tile adhesive
  • Designed to be inserted into the U-shaped groove of the matching hard PVC support profile
  • The profile can be used for lateral transitions to the wall or the adjoining floor
  • Available in brushed stainless steel
  • Canada Patent No. 2729076 more less

Product type

Select all options to find the
specific product you want to buy.

Find recommended accessories here

The Schluter®-SHOWERPROFILE-S system profiles represent an elegant solution for finishing the area between the floor and the first course of wall tile in a way that eliminates cutting wedges of tile and ensures a consistent elevation of the first course of wall tile in KERDI-LINE applications. SHOWERPROFILE-S consists of a trapezoid-perforated anchoring leg with a groove, which accepts a tapered brushed stainless steel profile that matches the slope of the KERDI-SHOWER-LT shower tray. The profile is adjusted to cover the exposed wall area and forms the visible surface.

The Schluter®-SHOWERPROFILE-S requires no special maintenance and is resistant to mold and fungi. Stainless steel exposed to the environment or aggressive substances should be cleaned periodically using a mild household cleaner. Regular cleaning maintains the neat appearance of stainless steel and reduces the risk of corrosion. All cleaning agents must be free of hydrochloric acid, hydroflouric acid, and chlorides. Stainless steel surfaces develop a sheen when treated when treated with a chrome-polishing agent. Do not use abrasive or alkaline cleaning agents.

1. Measure the height of the area to be covered at the lowest point. Next, measure the length of the area and mark the profile where it is to be cut at both ends. Remove the protective foil and cut the tapered profile and support section to length.

2. Place the tapered profile into the support section and apply Schluter-SET, Schluter-ALL-SET, Schluter-FAST-SET, or unmodified thin-set mortar to the fleece on the back side of the profile.

3. Press the profile into place and align it flush with the wall tile. Immediately clean away any excess setting material. Install adjacent tiles on the shower base.

Note: The Schluter®-PROCUT-TSM cutting wheel can be used with an angle grinder set to low speed to cut the stainless steel profiles. The SHOWERPROFILE-S support section can be cut with snips. Please read and follow all safety instructions from the grinder manufacturer to prevent injury.

Brochures and Pamphlets

Shower Brochure
2.48 MB
Curbless Brochure
1.16 MB

Data sheets

Shower System Data Sheet
5.23 MB


Shower System Warranty
29.91 KB

Product Table

26.17 KB
415.28 KB


Shower System Installation Handbook
1.7 MB

How do I cut profiles?


Schluter™ profiles are available in a variety of different materials , so methods for cutting vary. Below are best practices for cutting according...

Read more

Spec. Guides

Product Spec Guide 2019
1.25 MB

Specify our products using the

Specification Logo

Watch & Learn
About the product

Schluter®-KERDI-LINE Grate Assembly & SHOWERPROFILE-S/-R System Profiles

Schluter®-KERDI-LINE Grate Assembly & SHOWERPROFILE-S/-R System Profiles

How to order the SHOWERPROFILE-S/-R

How to order the SHOWERPROFILE-S/-R


Find some existing tutorials and project documentation videos to learn how-to get the best out of our products - for more fun in your life, start now!

Watch more videos / playlists

Accessories / Profiles


Accessories / Profiles


Prefabricated Substrates