Schluter®-BARA-ESOT

Skirting support profile for exterior applications

Schluter®-BARA-ESOT is a skirting support profile made of stainless steel for use in applications where no load-bearing substrate is available to support the skirting tiles. These substrates include metal flashing or bituminous waterproofing layers that are used at floor/wall transitions on balconies and terraces.
  • Designed for exterior applications at wall/floor transitions
  • Perforated anchoring leg is anchored between setting bed and tile
  • Base tiles installed on BARA-ESOT will resist normal impact caused by brooms or mops
  • Available in stainless steel
 ...read more  ...show less

Product type

Select all options to find the
specific product you want to buy.

Find recommended accessories here

Schluter®-BARA-ESOT is a stainless steel right-angle support profile for attaching base tiles to non-load-bearing substrates. These substrates include metal flashing or bituminous waterproofing layers that are used at floor/wall transitions on balconies and terraces. A foam insulation strip, cut to the same height as the base tile, is placed between the vertical leg of the profile and the wall to prevent a force-conductive bond.

The trapezoid-perforated anchoring leg of BARA-ESOT is anchored between the setting bed and the tile. The special perforations of the vertical leg position BARA-ESOT approximately 1/32" (1 mm) from the insulating strip and promote a mechanical bond between the thin-set mortar and vertical leg.

Base tiles installed on BARA-ESOT will resist normal impact caused by brooms or mops.

1. Apply a foam insulation strip to the wall at the height of the tile base.

2. Using a notched trowel, apply thin-set mortar over the floor area where the profile is to be placed.

3. Embed the horizontal anchoring leg of BARA-ESOT into the mortar while pressing the vertical leg of the profile against the insulation strip.

4. Trowel additional thin-set mortar over the anchoring leg and embed the floor tiles into the mortar, ensuring full coverage and support of the tile.

5. Apply thin-set mortar to the back of the base tiles and attach them to the vertical leg of the profile. The mortar must penetrate the profile perforations to ensure firm adhesion of the base tiles. Prior application of the foam strip prevents a force-conductive bond to the wall. A joint of approximately 3/16" (5 mm) should be left between the floor tile and the base tile. The joint must then be filled completely with grout or setting material.

6. Seal the wall connection above the base tile with an appropriate sealing compound.

7. Please note: The height of the base tile must either meet or exceed the height of the support profile’s vertical leg. However, the foam insulation strip must be applied at full base tile height.

Data sheets

Balcony and Terraces Data Sheet
914.76 KB
Pdf

Product Table

11202-preview
19.55 KB
BalconyProfiles_GutterSystems
898.52 KB
Pdf

Warranties

BalconyandTerrace-Profiles-Warranty
57.34 KB
Pdf

CAD drawings

schlueter_cad_bara_esot_metr
27.13 KB
DWG
schlueter_cad_bara_esot_inst
47.92 KB
DWG

Specify our products using the

Specification Logo

Balcony Profiles

Schluter®-BARA-RWL