Schluter®-BARA-RWL

Schluter®-BARA-RWL is a color-coated aluminum edging profile with drainage holes for the perimeters of balconies and terraces where large-format pavers are installed over loose-laid gravel or elevated sub-structures.

  • Designed for the perimeters of balconies and terrace coverings loose-laid on gravel or elevated sub-structures
  • Anchoring leg is available with a special radius perforation so that the profile can be used to form curves
  • Available in color-coated aluminum
Read more

Schluter®-BARA-RWL is a color-coated aluminum edging profile with drainage holes for the perimeters of balconies and terraces where large-format pavers are installed over loose-laid gravel or elevated sub-structures.

  • Designed for the perimeters of balconies and terrace coverings loose-laid on gravel or elevated sub-structures
  • Anchoring leg is available with a special radius perforation so that the profile can be used to form curves
  • Available in color-coated aluminum
Configure to Price Add to
Project
Dealer
Locator
Product
Table

Product successfully added to Project List

You can now access your Project List or stay on this page

Go to Project List Continue browsing

Uppsss...

Sorry, something went wrong. Please try again later.

Continue browsing
Share
Schluter<sup class='regsign'>®</sup>-BARA-RWL

Schluter®-BARA-RWL

Edging profile with drainage holes for large-format pavers
Schluter®-BARA-RWL
Schluter®-BARA-RWL
Schluter®-BARA-RWL
Schluter®-BARA-RWL
Schluter®-BARA-RWL

Product type

Next

Schluter®-BARA-RWL is a color-coated aluminum, L-shaped finishing profile for large-format pavers that are laid on loose gravel layers or stilted assemblies above a waterproofing layer and drainage layer. The trapezoid-perforated anchoring leg of BARA-RWL is placed along the edge, on top of the waterproofing layer, and adjusted to the proper height and alignment. The vertical finishing leg covers the edge of either the entire surface assembly or just the gravel layer or stilts. Profile heights from 9/16" to 5-29/32" (15 to 150 mm) allow for any type of edge formation. Drainage holes, spaced at approximately 2-15/16" (75 mm), are incorporated at the transition of the anchoring leg and the finishing leg to ensure the proper drainage of any collecting seepage water.

BARA-RWL is available with a special radius perforation “R” so that the profile can be used to form curves.

1. Select BARA-RWL according to the height of the floor construction to be covered. Prefabricated corners and connectors are available for inside and outside corners. Abut the profile ends of BARA-RWL, leaving an approx. 3/16" (5 mm) joint. Cover the joint with the clip-on connector.

2. Before the drainage membranes (TROBA or TROBA-PLUS) are installed, set the trapezoid-perforated anchoring leg of the finishing profile, BARA-RWL, onto the waterproofing layer and, if required, adjust to the proper height and alignment with dots of mortar.

3. If BARA-RWL is used as a gravel edge profile, the gravel layer should abut the vertical profile leg just below the upper lip. The concrete pavers are laid loosely on top of the leveled gravel layer.

4. If BARA-RWL is used as a finishing profile in conjunction with stilted floor coverings, the profile covers the exposed edge of the covering assembly. The support pedestals are laid on top of the trapezoid-perforated anchoring leg of BARA-RWL. The concrete pavers are then set onto the pedestals.

Note: To ensure unobstructed drainage at the edge areas of the covering, make certain during installation that drainage openings in the drainage membrane and profile and that spaces between the pedestals remain open.

BARA-RWL requires no special maintenance or care. The coatings on the color-coated aluminum profile are colorfast and UV-resistant. Damaged surfaces shall be painted over.

Downloads

Data sheets

Warranties

FAQ

Architectural Material

Specify our products using the Specification Logo

/

Schluter®-BARA-RTK

Balcony profiles

Schluter®-BARA-RTK

Edging profile for balconies and terraces

Schluter®-BARA-RTP

Balcony profiles

Schluter®-BARA-RTP

Retrofit edging profile for balconies and terraces

Schluter®-BARA-RAKE

Balcony profiles

Schluter®-BARA-RAKE

Balcony edging profile with drip lip and drainage holes for Schluter-DITRA-DRAIN applications

Schluter®-BARA-STU

Balcony profiles

Schluter®-BARA-STU

Colored aluminum sheets used in conjunction with BARA profiles